1/2" DYNAMOMETRIC KEY WITH REMOVABLE CLAMP 70- 350Nm FACOM
FACOM
Reference 1911317
FACOM torque wrench with removable ratchet. Mechanism endurance: 50,000 cycles (wrenches up to 200 N.m). Possible use with accessories: - Attachment: 9 x 12 or 14 x 18 mm. - Diameter: 30 mm. One-way wrench usable for loosening by turning the bits. Numbered wrench delivered with ISO 6789 calibration
See more
| Type | Torque wrench |
|---|---|
| Dimensions carré | 1/2" |
| Length (mm) | 725 |
| Référence fabricant | S.306A350PF |
| Tightening capacity | 70-350 N.m |
Are you interested in this product?
Become a customer and benefit from
- A catalogue of over 300,000 references
- Dadvantageous tariff conditions
- Responsive and available customer service
-
Turnkey services to support you
on a daily basis
Description
- FACOM torque wrench with removable ratchet. Mechanism endurance: 50,000 cycles (wrenches up to 200 N.m). Possible use with accessories: - Attachment: 9 x 12 or 14 x 18 mm. - Diameter: 30 mm. One-way wrench usable for loosening by turning the bits. Numbered wrench delivered with ISO 6789 calibration certificate. The standard unit of measurement is the Newton metre, symbol "Nm": 1 metre kilo = 9.81 Nm (approx. 10 Nm). 1 ft.lb = 1.35 Nm 1 in.lb = 0.1128 Nm 1 In.Oz = 0.00705 Nm 1 Nm = 0.102 metre kilo (about 100 g/m). 1 Nm = 0.738 ft.lb 1 Nm = 8.863 in.lb 1 Nm = 141.8 In.Oz
Advices
- Maintenance:
Use a dry cloth to clean your spanner, do not use solvents or detergents.
Do not dismantle your spanner.
Keep the spanner clean and tidy.
Never exceed the maximum torque of your spanner, especially when unlocking and or tightening at an angle.
To prolong the accuracy of your torque tool, it is best to set it to the minimum torque before storing it in its box.
Accuracy maintenance:
It is advisable to have your spanner checked periodically (approximately every year or more often for intensive use) and in the event of a fall, on a control device, or by the FACOM metrology laboratory.
Accuracy verification and updating of documents:
The FACOM metrology laboratory issues verification statements or calibration certificates on request.
How to use
- Setting to the desired torque:
1 - Pull the ring towards the handle.
2 - Turn the handle and stop the vernier on the desired graduation.
3 - Release the ring which clicks in.
Tightening:
A - Place your spanner perpendicular to the tightening axis.
B - Place your hand in the middle of the handle.
C - Pull progressively and perpendicularly to the spanner.
D - At the "Click" release stop your effort immediately.
